Εμφάνιση ενός μόνο μηνύματος
  #755  
Παλιά 25-03-17, 17:20
mixalakis Ο χρήστης mixalakis δεν είναι συνδεδεμένος
Senior Member
 
Εγγραφή: 30-09-2014
Περιοχή: ΝΕΟ ΗΡΑΚΛΕΙΟ
Μηνύματα: 647
Προεπιλογή

ΤΙ ΗΤΑΝ ΤΟΥΤΟ??!!!!


απο που να ξεκινησω...?

απο την βρωμα του αιωνα...

απο τα καθαρισμα του νικου ....γυαλι...

τελειωσαμε με σφηνακια πολλαπλα του νικου με αλατονερο μεχρι να παρει μπρος ο ριακτορας...


νικο σε ευχαριστω πολυ γιατι εχασες και το εορτινο τραπεζι . φιλε σου χρωσταω ενα τραπεζι....τελος

υγ. σακη αυτος ο ριακτορας θελει αντλια για να ρουφαει το νερο?

βρηκα αυτο απο οδηγιες και διαχωριζει σε χρηση δυο αντλιες
"Reconnect this pipe and check all connections are tight, now open the little red inlet control tap fully and turn on your feed pump. Leave the reactor recirc pump off for now and run the pump until water starts to run from the effluent pipe. Give the reactor a bit of a shake to force any trapped air to the top and wait for all the air to escape from the effluent pipe.

When the reactor is clear of air turn on the recirculation pump, if using Rowalith C+ media the media should start to slowly fluidise within the reactor. I have used large coral skeleton in the PF601s( 20-30mm) with excellent results, dont expect this to fluidise though."
__________________
REEF LIGHT
Main display : 80x60x60h , Sump : 60x50x40h
Lighting : Kessil A360W Controller : Apex
Circulation: 2 X Tunze 6055 Return pump: Sicce 4000
Skimmer : RLSS 6
Heating : Eheim 300 Cooling : Teco TK500


Απάντηση με παράθεση
 
Page generated in 0,01444 seconds with 10 queries